ISO9001 OEM Iron removal system Automatic with 380V / 50Hz / 3phase
At initial status, both of the the and ‚ are full, and tƒ is
empty, after sometime for using of fluxing solution and it needs
treatment, open “pump 2”, at this time the fluxing solution in ƒis
pumped into , when it is full, the fluxing solution overflow into
‚through overflow pipe, when the ‚is full, “pump 2 “can be closed,
then blow the fluxing solution in ‚, add air and chemicals, leave
it calm for sometime, open “pump 1”, fluxing solution in treating
tank ‚is pumped into pressure filter by “pump 1”, after filter it
flows into transition tankƒ, the precipitation is carried out of
factory, this process is repeated, which can achieve fluxing
recycling and regeneration.
1. Electronic industry: Pre-filter for ultra pure water, chemical
products and pure water
2. Food and beverage industry: filter for mineral water, wines and
3. Medicine industry: filter for drug liquid, gases
4. Chemical industry: filter for organic solvent
5. Petroleum industry: filter for oil-field flooding
1. Automatic backwash and manual backwash
2. Automatic switch on when low water level, and switch off when
high water level
3. Water shortage protection for multi-stage pump
4. Protection when no voltage, under-voltage, over-current, short
circuit and creepage
5. Full stainless steel structure, durable and easy to clean.
6. Integrating water flow indicator, conductivity indicator,
pressure indicator, control panel
7. China Top Brand or world famous brand electrical, switch and
8. Core components of RO system are imported, USA Filmtec Dow
9. Run and produce water continuously, high degree automation
> After sale-service
The above machine which we supply it to you, we can give you one
years after sales warranty, we can also send our engineer to you
factory to install this equipment and train your staff, but the Buyer should pay the round air ticket cost and arrange the
hotel accommodation as well as the means for Seller’s engineer. We will send some free set of spare parts for you change it.
Zinc ash is mainly composed of ZnO, Zn and metal chloride etc..
Per 1kg zinc ash contains Zinc >800g .
Zinc consumption that caused by ash occupied 20〜30% of total amount
Fluxing is a process before galvanizing.
After rinsing put the black workpieces into the fluxing tank, keep
them in ZnCI2—NH4CL double salt aqueous solution about 0.5～1min, heating to keep the
temperature during 50～70℃.