Features of Low Price of Silicone Rubber for Mold Making / manual
mold making / shoe sole mold
Shoes mould Making RTV-2 Silicone Rubber is a two-component
material, and RTV-2 silicone rubber is consisted of Part A silicone
base and Part B CA30 curing agent, and the silicone base and curing
agent can cure at room temperature by a condensation reaction.
These materials can be cast into the cured silicone mould: Shoe
mould making, sand casting etc.
Characteristics of Low Price of Silicone Rubber for Mold Making /
manual mold making / shoe sole mold
1. Good flow ability and long working time
2. Medium hardness stone mold making
3. High tear and tensile strength
4. Easy de-mould from complex replica parts
5. Acid and alkali-resistance
6. Low linear shrinkage
Instructions for Low Price of Silicone Rubber for Mold Making /
manual mold making / shoe sole mold
1. Make sure the surface of the original is clean and free of loose
material.
2. Weight 100 Part A base and 2 parts of CA30 Curing Agent in a
clean container.
3. Stir Part A base silicone before use thoroughly, as filler
separation may occur upon prolonged storage.
4. Mix Part A and Part B evenly until the CA30 completely dispersed
in the base.
5. Pour the mixed Part A base silicone and CA-30 curing agent as
soon as possible onto the original
6. De-mold after 24 hours, it is will improve the replicate times
of silicone mold.
Note: It is strongly recommended that entrapped air be removed in a
vacuum chamber, allowing the mix to completely expand and then
collapse. After a further 1-2 mins under vacuum, the mix should be
inspected and can be used if free of air bubbles. A volume increase
of 3-5 times will occur on vacuum de-airing the mixture. So a
suitably large container should be chosen.
Storage of Low Price of Silicone Rubber for Mold Making / manual
mold making / shoe sole mold
When the Shoes Mold Making RTV-2 Silicone Rubber is stored at or
below 30 ° C (85° F) in the original unopened containers,
RTV3010/3015 silicone base and CA30 curing agent have a usable life
of 12 months from the date of production.
Note of Low Price of Silicone Rubber for Mold Making / manual mold
making / shoe sole mold
Shoes Mold Making RTV-2 Silicone Rubber is an industrial product
and must not be used in food molding, dental human skin molding
applications.
Technical parameter of Silicone Rubber for Mold Making| Item | RTV3025 | | Color | Liquid white | | Curing agent | CA30 | | Mixing ratio | 100:2 | | Mixed viscosity | 20000 cps | | Working time | 5-10 Minutes | | Curing time | 4-6 Hours | | Hardness | 25 Shore A | | Tear Strength | 20 N/mm | | Tensile Strength | 2.6 MPA | | Relative density | 1.0-1.1 g/cm3 | | Elongation at break | 600% |
|
100:2 Tin Cured RTV2 Silicone Mold Rubber For Flower Pot Mold
